Boot with or without UEFI (in progress)
- Legacy Boot
- UEFI Boot
- Install with UEFI
- Punkt 4
- Punkt 5
This article was tested succesfully with the following Kanotix versions:
- Kanotix Dragonfire
- Kanotix Spitfire
- Kanotix Steelfire
- Kanotix Silverfire
- Kanotix Speedfire
If you boot the Kanotix-Iso it will start in UEFI or Legacy mode.
1. Legacy Boot
If you see this grub-screen (with Memtest) the iso is booted in Legacy mode.
After install you have to start the install also in Legacy mode !
2. UEFI Boot
If you see this grub-screen (with EFI Shell) the iso is booted in UEFI mode.
After install you have to start the install also in UEFI mode !
3. Install with UEFI
Before you start, you must create for Uefi Bios an GPT Partition Table if not already installed!
You have to mount a FAT32 partition on /boot/efi
100-512 mb recommended
So create a FAT32 partition and mount during installation:
(this is only an example, Partition is only 20 gb)
4. Punkt 4
dual boot mit win uefi (use gpt)
do not use uefi when windows is installed in legacy mode