Boot with or without UEFI (in progress)

---

This article was tested succesfully with the following Kanotix versions:

• Kanotix Dragonfire

---

If you boot the Kanotix-Iso it will start in UEFI or Legacy mode.

1. Legacy Boot

If you see this grub-screen (with Memtest) the iso is booted in Legacy mode.
After install you have to start the install also in Legacy mode !

2. UEFI Boot

If you see this grub-screen (with EFI Shell) the iso is booted in UEFI mode.
After install you have to start the install also in UEFI mode !

3. Install with UEFI

You have to mount a FAT32 partition on /boot/efi
100-300 mb recommended

So create a FAT32 partition and mount in the installer:
(this is only an example Partition is only 20 gb)

4. Punkt 4

todo